Pesticide industry wastewater causes toxic effects and bioaccumulation and high chemical oxygen demand (COD) and suspended solids (SS) concentrations of these wastewaters cause environmental problems. Furthermore, the wastewater caused from pesticide industry indicates great alteration in the wastewater characteristics subjected to the kind of agrochemicals produced and on the use of materials manipulated. In this study wide found and economical coagulants; ferrous (III) chloride, alum, ferrous (II) sulphate, and also a polyelectrolyte magnafloc were used for a physicochemical treatability study and reusing of the wastewater was evaluated. SS and COD removal was ensured with coagulation and flocculation process, however, it was seen that this process was not sufficient for discharging to receiving water environment. The optimum pH values for iron (III) chloride, alum and iron (II) sulphate were found to be 7.21, 8.12 and 7.18, respectively and optimum coagulant dosages were 250 mg/L for iron (III) chloride and iron (II) sulfate, and 300 mg/L for alum. The COD removal efficiencies were 43%, 47% and 42% for iron (III) chloride, alum and iron (II) sulphate respectively and also SS removal efficiencies were 44% for iron (III) chloride, 47% for alum, and iron (II) sulphate for 39%. Optimum polyelectrolyte doses were determined to be 0.2 mg/L for alum and iron (II) sulfate and 0.3 mg/L for iron (III) chloride. Consequently, it was ascertained that the wastewater originated from pesticide industry could be reused in production after the coagulation/ flocculation process.
Pestisit endüstrisi atıksularının toksik etkilere ve
biyolojik birikime neden olması ve bu atıksuların yüksek kimyasal oksijen
ihtiyacı (KOİ) ve askıda katı madde (AKM) konsantrasyonları çevresel açıdan
önemli problemlere yol açmaktadır. Ayrıca, pestisit endüstrisinde üretilen
pestisitlerin türüne ve kullanım özelliklerine göre atıksuların
karakterizasyonu değişebilmektedir. Bu çalışmada yaygın ve ekonomik olarak
kullanılan alum (Al2(SO4)3.18H2O),
demir (II) sülfatın (FeSO4.7H2O) ve demir (III) klorür
(FeCl3.6H2O) koagülantları ve anyonik polielektrolit
(magnaflok) ile koagulasyon flokulasyon prosesi ile fizikokimyasal
arıtabilirlik çalışması yapılarak atıksuyun üretimde yeniden kullanımı
değerlendirilmiştir. AKM ve KOİ giderilmesinde koagülasyon – flokülasyon
prosesinin giderim sağladığı ancak alıcı ortama deşarj için çok yeterli
olmadığı görülmüştür. Demir (III) klorür, alum ve demir (II) sülfat için
optimum pH değerleri sırasıyla 7,21, 8,12 ve 7,18 ve optimum koagülant dozajları
demir (III) klorür ve demir (II) sülfat için 250 mg/L, alum için ise 300 mg/L
olarak bulunmuştur. KOİ giderim verimleri demir (III) klorür, alum ve demir
(II) sülfat için % 43, % 47 ve % 42, AKM giderim verimleri ise, demir (III)
klorür için % 44, alum için % 47 ve demir (II) sülfat için % 39 bulunmuştur. Optimum
polielektrolit dozları alum ve demir (II) sülfat için 0,2 mg/L, demir (III)
klorür için ise, 0,3 mg/L olarak belirlenmiştir. Sonuç olarak bu
koagulasyon-flokulasyon prosesi sonucunda elde edilen suyun geri kazanılarak
üretimde kullanılabileceği belirlenmiştir.
Primary Language | Turkish |
---|---|
Subjects | Engineering |
Journal Section | Research Articles |
Authors | |
Publication Date | January 31, 2019 |
Submission Date | June 12, 2018 |
Acceptance Date | September 17, 2018 |
Published in Issue | Year 2019 Volume: 5 Issue: 1 |
This journal is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.